Comparative study on effect of blending,thermal barrier coating (LHR) and injector nozzle geometry on biodiesel-fuelled engines

Increased petroleum prices, increased threat to the environment from exhaust emissions and global warming have generated intense international interest in developing renewable and alternative non-petroleum fuels for internal combustion engines. Evolving suitable technology for addressing energy crisis creates a continued investigation into the search for sustainable and clean-burning renewable fuels. This work investigates suitability of different non-edible-derived biodiesels such as cotton seed oil methyl ester (COME), Honne oil methyl ester (HnOME) and Rubber seed oil methyl ester (RuOME) to four stroke, single cylinder compression ignition (CI) engine. Engine tests were conducted to study the effect of fuel blending, thermal barrier coating (TBC) or Low Heat Rejection (LHR) and injector nozzle geometry on the performance, combustion and emission characteristics of COME, HnOME and RuOME in the modified CI engine. Blends of biodiesels with diesel were varied from 20 to 80% in steps of 20%. Two thermal barrier coatings of partially stabilized zirconium (PSZ) and aluminium oxide (Al₂O₃) were provided on the engine to make it fully adiabatic. Nozzle injectors of 3, 4 and 5 holes, with size of orifice varied from 0.2 to 0.3 mm size were selected for the study. It was concluded that B20 biodiesel blend, PSZ-coated engine and four hole nozzle injector of 0.2 mm size resulted in overall better engine performance with increased brake thermal efficiency (BTE) and reduced HC, CO, smoke emissions for the fuel combinations tested. Combustion analysis to study the effect of biodiesel blends, LHR coatings, injector nozzle geometry on the performance of the biodiesel-fuelled engine has been presented to give more insight into the behaviour of operation.     

Experimental study on explosion inhibition by heptafluoropropane and its synergy with inert gas

The inhibition effect of heptafluoropropane (CF₃CHFCF₃) on methane explosions under different inhibitor concentrations in a closed vessel was studied. A high-speed camera and a pressure sensor were adopted respectively to record flame propagation characteristics and pressure data. Results indicate that the relationship between flame propagation and pressure rising was correlated. As the equivalent ratio (ϕ)≤1, the pressure presented a trend of rising firstly and then decreasing with increasing CF₃CHFCF₃ concentration, and it was found that there existed a critical concentration for pressure decrease. As ϕ > 1, the pressure exhibited a decreasing trend. Although the pressure appeared to seemingly increase, the moment that the pressure began to rise (t_rise) and the moment that the maximum explosion overpressure appeared (t_Pmax) were obviously delayed. The average rate of pressure rise ((dP/dt)_ave) was decreased as the concentration of CF3CHFCF3 increased. It indicates that CF₃CHFCF₃ can effectively reduce the explosion reaction rate. The critical concentration of CF₃CHFCF₃ for complete inhibition was determined. Meanwhile, the synergy of CF₃CHFCF₃-inert gas can improve the inhibition effect. Compared with CF₃CHFCF₃–N₂, the synergy of CF₃CHFCF₃–CO₂ presented a better inhibition effect, and the inhibition effect was increased with increasing inert gas concentration. And the mechanisms of physical and chemical effects on explosion inhibition were analyzed.     

成都地区污染天气分型及其污染气象特征研究

污染天气分型研究对空气质量预报、污染源总量控制等具有重要的意义。基于2013年1月~2014年12月高空及地面天气形势划分了成都市的天气类型并探讨各天气类型下的空气质量状况及其污染天气特征,以期为空气质量预报和预警提供依据。结果表明,空气污染过程中,500 hpa环流形势主要有两槽一脊型、一槽一脊型、纬向型、槽脊同位相型等,其中两槽一脊型和槽脊同位相型控制下的空气质量最差。发生空气污染时,地面环流形势可分为高压型、高压后部型、高压底部型、低压型、低压顶部型、低压前部型、低压底部型、鞍型场型、冷锋前部型和均压场型,其中高压型、高压底部型、高压后部型控制下的空气质量最差。     

Rebound effect and its decomposition – an analysis based on energy types in China

Rebound effect derived from energy efficiency improvement has been widely invested. However, most of studies focus on the rebound effect of the energy composite level and neither distinguish nor compare different energy types. We compare the differences in energy saving and energy rebound between primary and secondary energy sources, and further decompose the rebound effect into production rebound part and final demand component. To do so, we add a module for rebound into a comparative state China-CGE model. We design and test two simulation scenarios using the model. In Scenario 1, all production sectors’ energy efficiency of using primary energy increases by 5%. In Scenario 2, all production sectors’ energy efficiency of using secondary energy increases by 5%. The results show that Scenario 2 leads to more GDP growth and more energy saving. Our scenarios show rebound effects range between 9.6% and 27.9%, and in general are higher when energy efficiency of using primary energy sources is improved. Our decomposition analysis shows that improving energy efficiency in production sectors would stimulates energy use of final demand. Indeed, the consumption side has significant contribution to rebound in secondary energy use, especially in crude oil and gas. This study reveals that improving efficiency of using secondary energy is better than improving that of primary energy, both in terms of economic impact and energy rebound. And complementary policies that prevent energy services prices from falling too much can be adopted to reduce rebound. Controlling residential energy use could also be effective in reducing rebound, this has particular implication to economies in which residential energy consumption are far from saturation.     

低气压试验标准及试验技术分析

详细阐述了低气压环境对装备的各种影响,介绍了我国主要军用、民用环境试验标准中规定的试验程序及其应用对象,分析了有关低气压试验条件,包括低气压贮存、工作和快速/爆炸减压的试验条件和变化速率,最后简单介绍了低气压试验设备的一般要求、特别是快速减压和爆炸减压设备的使用和低气压试验技术。     

TiO2载体对Mn-Ce/TiO2催化剂脱硝活性的影响

以TiO₂为载体,选取过渡金属元素Mn为活性组分,稀土金属元素Ce为活性助剂,采用分步共混法制备了Mn-Ce/TiO₂催化剂（活性组分负载量16%）,系统研究了TiO₂载体的晶型和晶粒尺寸对催化剂脱硝活性的影响。实验结果表明：分别以锐钛矿型和金红石型TiO₂为载体制备的催化剂,其低温脱硝活性相差不大,活性组分均以无定型态高度分散于载体中,以金红石型TiO₂为载体制备的催化剂中部分TiO₂转变为锐钛矿型;以不同晶粒尺寸TiO₂载体制备的催化剂的低温脱硝活性相差较大,比表面积较大、晶粒尺寸较小的TiO₂载体制备的催化剂,其脱硝活性低于晶粒尺寸较大的TiO₂载体制备的催化剂。     

Case study of landfill leachate recirculation using small-diameter vertical wells

A case study of landfill liquids addition using small diameter (5 cm) vertical wells is reported. More than 25,000 m³ of leachate was added via 134 vertical wells installed 3 m, 12 m, and 18 m deep over five years in a landfill in Florida, US. Liquids addition performance (flow rate per unit screen length per unit liquid head) ranged from 5.6 × 10^?8 to 3.6 × 10^?6 m³ s^?1 per m screen length per m liquid head. The estimated radial hydraulic conductivity ranged from 3.5 × 10^?6 to 4.2 × 10^?4 m s^?1. The extent of lateral moisture movement ranged from 8 to 10 m based on the responses of moisture sensors installed around vertical well clusters, and surface seeps were found to limit the achievable liquids addition rates, despite the use of concrete collars under a pressurized liquids addition scenario. The average moisture content before (51 samples) and after (272 samples) the recirculation experiments were 23% (wet weight basis) and 45% (wet weight basis), respectively, and biochemical methane potential measurements of excavated waste indicated significant (p < 0.025) decomposition.     

基于铁路客运的中国城市可达性及类型研究

为探究铁路网络时空压缩效应对城市可达性的影响,基于2009年和2014年铁路列车时刻表数据,结合传统数理统计方法及空间分析方法,对中国地级以上城市可达性及其格局演变进行深入分析。结果表明:(1)铁路客运的数量和类型上均有较大变化,特别是始发列车及动车组的大幅增加及高铁的开通运行,中国城市可达性得到一定程度提升,但城市可达性改善地域差异性显著。(2)北上广三大核心城市在城市可达性等级体系中第一层级地位稳固,交通区位条件的差异使得城市可达性等级体系产生一定变化。(3)中国城市可达性绝对及相对差距均呈现出不断扩大趋势,列车停靠数量的极化效应显著、新增加的高速客运更多地向高等级中心城市集聚,铁路基础设施的建设正在重塑中国生产力格局。(4)从城市功能属性及规模属性视角,以始发列车和停靠列车中位数为临界值,将中国城市划分为高规模高功能、高规模低功能、低规模高功能、低规模低功能等4种类型,并依次分析城市分布特征及成因,为铁路客运的合理配置及交通网络优化布局提供参考。     

固相萃取-GC/MS法测定地表水中3-甲基吲哚

采用微球硅胶键合C_(18)固相萃取柱萃取水样中的3-甲基吲哚,并用气质联用法测定,方法在0 mg/L~10.0 mg/L范围内线性良好,方法检出限为0.2μg/L。空白水样3个质量浓度水平的加标回收率为89%~94%,7次测定结果的RSD为2.3%~6.9%。用该方法测定7个实际地表水样品,其中4个地表水样品检出3-甲基吲哚,地表水样的加标回收率为81.5%~97.0%。     

Water saving effect on integrated water resource management

This study proposes an improved integrated water resource management (IWRM), in which water conservation was analyzed for the entire water use process. A multi-objective optimization method was applied to optimize the IWRM, which investigated the reduction of freshwater consumption and the total water supply cost. Customer's preference for saving water and an end use analysis (EUA) was applied in the water conservation analysis. Taking Tianjin as the study area, a reduction in customer's economic pressure (EP) was utilized to evaluate the degree of the customer's preference for saving water. The results revealed that agriculture had a greater preference for saving water than other sectors, where as the public had the weakest motivation for saving water. Improving the transportation method could contribute 62.1% of the total water savings in the agriculture sector. The optimization of the IWRM demonstrated that the local freshwater savings would be 21.5%, and the total cost for water supplies would decrease by 13%. However, a government subsidy of 87.5 million Yuan would be needed. Additionally, by analyzing the change in the amount of water savings affected by water price, the appropriate water price increase range was suggested to be 1.5–1.7 times the original price.